Kent homes built before the 1980s in Franklin Township and around the University District often have original wiring and gas lines that complicate oven repairs. Cold humid continental winters can cause igniters to fail when temperatures drop below freezing, especially in homes near the Cuyahoga River where moisture levels stay higher. Technicians at Johann Co. check both the control board and the gas valve during every visit because a single faulty sensor can mimic multiple problems.
Electric ovens in Downtown Kent and Brady Lake properties frequently show element burnout after repeated high-heat cycles during warm summers. Replacement parts must match the original voltage to avoid tripping breakers in older panels common to Portage County housing stock. We test the bake and broil elements separately and verify the thermostat calibration before leaving the job site.
Stoves located near the Davey Tree Expert Company campus or along routes to Akron and Streetsboro face extra vibration from nearby traffic that loosens connections over time. Gas models require leak checks at every service call because winter ground shifts can stress supply lines. Johann Co. carries common elements and igniters on the truck to complete most repairs the same day within our Mon–Fri 8am–6pm and Sat 9am–2pm hours.
Technician insight
In Kent the thing that catches most people out with oven and stove repair is older wiring in University District homes built before the 1970s. Cold winters make the difference because thermal contraction loosens connections that only show up once the oven has been running for twenty minutes.
Brady Lake Gas Range No-Heat Call
Homeowner in Brady Lake reported the oven would not reach temperature during a cold snap. We found a cracked igniter and a loose wire at the valve caused by winter ground movement near the river. Replaced the igniter, secured the connection, and confirmed even burner operation before leaving.
Oven and Stove Repair Services We Offer
✓Gas Stove Burner Repair
Restores even flame distribution on gas ranges common in older Kent homes by cleaning or replacing burners and orifices.
✓Electric Oven Element Replacement
Swaps failed bake or broil elements in electric ovens found throughout University District and Franklin Township properties.
✓Stove Igniter Replacement
Replaces worn spark or glow-bar igniters that fail more often after cold Portage County winters.
✓Oven Temperature Calibration
Adjusts thermostats and sensors so ovens maintain accurate temperatures in homes near the Cuyahoga River.
✓Range Control Board Repair
Diagnoses and replaces faulty electronic boards that control modern stoves in Downtown Kent residences.
Oven and Stove Repair Cost in Kent, OH
| Service | Typical Range | What Affects It |
|---|---|---|
| Electric Element Replacement | $180–$320 | Varies by single or double oven and part availability |
| Gas Igniter Replacement | $150–$275 | Higher for sealed burner models |
| Control Board Replacement | $250–$450 | Depends on brand and programming needs |
| Temperature Calibration | $95–$160 | Often combined with element work |
Ranges are typical for Kent, OH and confirmed with an exact written quote before any work starts.
How it works
- 1
Initial Diagnosis
Technician inspects the unit at your Kent address and tests power, gas supply, and controls.
- 2
Part Identification
We identify the exact element, igniter, or valve needed and confirm availability from the truck or local supplier.
- 3
Repair Execution
Parts are installed and connections are secured, with leak checks performed on all gas models.
- 4
Final Testing
Oven is run through full cycles to verify temperature accuracy and burner performance before departure.
Pricing
Upfront quotes given after inspection; typical jobs fall within published ranges.